How to Use a Penis Pump Properly | Instructional Guide

When I was new to dick pumps, I was also wondering about the same thing. I hear this from a number of men but was too shy to ask. If you are looking for answers to these questions, then you are just on the right page.

This article aims to give you a concrete idea on how to use a penis pump properly and effectively. So, without further ado, let’s get started!

Penis Pump Instructions

To give you a comprehensive instruction on how to use penis pumps, let’s get started by familiarizing its different parts. Below is a photo of a dick pump that you will usually find in the market.

A penis pump is consists of a pump attached to a cylinder tube with a comfort sleeve or seal and a flexible tube. Here’s an overview of each part.

Pumping cylinder/chamber. This is the part of the device where you will place your penis in. This can be made in different materials like plastic, fiberglass or glass. The structure should be sturdy enough to withstand a certain amount of vacuum pressure that comes with pumping and large enough to accommodate different penis sizes. Some come with a gauge where you can easily measure your member and monitor your gains.

Tube. A flexible tube is used to transport the air and create a vacuum during pumping to the cylinder or chamber.

Sleeve, penis band or constriction ring. Penis pumps usually come with a sleeve for a good sealing power. This is necessary to produce a powerful vacuum and make the pump system effective. You will usually find this on the base of the airtight chamber. It provides a tight grip on the base of the erect penis and keeps the cylinder airtight.

Hand pump. This is used to create a suction. This is the part of the device that draws air from the chamber during the enlargement process. This is usually connected to the cylinder by a flexible tube where the air passes out towards the pump. However, this may not be present in electric penis pumps which are powered by batteries or are rechargeable.

Best Proper Way to Use a Penis Pump

Now, that you are already familiar with the different parts of a penis pump, it’s time to start pumping. How do you use a penis pump? Here’s how to start right and do it accurately to see results.

I understand that it’s easy to skip this, but reading the manual is very important. You are dealing with something involving your genitalia, so you shouldn’t take any chances. Reading the manual is part of taking precaution. So, pick the manual and read!

Make sure that the pump is clean and ready. If you are using a hydro pump, make sure that it has water.

When you’re ready and the pump is ready, it’s time to slip your member insider the cylinder. Depending on the pump you can have your penis flaccid, hard or semi-erect.

Press the base of the pump firmly to your body, creating an airtight seal between your skin and the pump. Please note that it might be necessary to trim the pubic hair around the base of the penis so that the pump can sit completely flat against your pubic bone.

Depending on the type of your dick pump, you may either need to place your finger over the quick release valve or twist it so that it shut.

If you are using a manual pump, pump slowly. Between each pump, allow your penis to adjust to the changing pressure within the chamber before squeezing the bulb for a second or third time. Continue pumping until fully erect.